Faucet maintenance knowledge

Faucets are indispensable in our daily life. Different types of faucets are different in their maintenance. The following will tell you how to maintain the Faucet.

Basin faucet

Buy Single Lever Basin Tap should pay attention to the outlet diameter, most of the market today is a national standard product, hard pipe water, so you should pay attention to set aside the height of the mouth, down from the basin down to 35 cm is most appropriate. When installing, the Angle Valves must be fixed with the hot and cold water pipes of the wall outlet. When you find a distance between the angle valve and the faucet Stainless Steel Hose, buy a special extension tube to connect.

Remember, do not use other pipes to connect, because if the water pressure is high, it is easy to fall off, leak, and cause losses to you. If the inlet pipe is longer than the outlet pipe, you can cut it off according to your needs. If the angle is not appropriate, you can bend it to your desired position. Remember: Do not talk hard and bend to 90 degrees or greater than 90 degrees. When installing the basin to remove water, do not forget to purchase the faucet's small connector (short for the faucet).

When you have purchased showers, bathtubs,Shower Tub Mixer, wall-mounted faucets, you can choose the appropriate height to bury the water pipe. The distance between hot and cold water pipes must reach 15 points. Before installation, you must not forget to flush the water pipe to avoid excessive water quality and damage the mixer. If the elbow between the faucet and the wall joint is too long, cut off part of the 4-way wire. Remember: The 6-point connection to the faucet does not seem to be disorderly.

After purchasing a Concealed Basin Mixer, it is usually necessary to embed the valve plug of the faucet in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the valve plug cannot be embedded. The plastic protective cover of the valve plug should not be easily removed when it is embedded so as not to damage the valve plug in cement and other miscellaneous services. In addition, when embedding the valve core, it should also pay attention to the direction of the valve core up and down, left and right, so as not to miss the valve core.

When you install the shower and Tub And Shower Mixer, don't forget the filter inside the shower pipe when installing the shower. When installing the shower, the water pressure must not be too high, generally 1-3 kg is best and cannot exceed 5 kg. If the water pressure is too high, the water restrictor in the faucet valve core can be opened to reduce the water pressure, and the water saving effect can also be achieved.

Before installing the Thermostatic Bath Shower Mixer, please check whether the water pipe is left hot and right cold. Remember not to connect the hot and cold water pipes to the wrong pipe to prevent the faucet from working properly. Gas and solar water heaters cannot use thermostats because the water pressure is too low. Do not forget to install the hot and cold water filter when installing the thermostat.

【Daily maintenance】

In the process of using the faucet, it is necessary to frequently maintain and clean the scale on the surface of the faucet and the water sand in the outlet nozzle to protect the chrome plating layer on the surface of the faucet as bright as new. Do not use a rough towel and cloth to wipe the faucet, so as not to scratch the chrome plated layer, and do not touch the faucet with acid-alkaline items to avoid damaging its brightness.